Racing Brake Slotted OE Replacement Rear Rotor Ring for Nissan GT-R R35 2009+

Details

Includes hardware for installation.

These OE rotor replacement rings although are made from a better design in cooling vanes and metallurgy. However, due to the OE axle blocking the air inlets, surface mount rotors (such as these OE two piece) don’t permit cool air to enter the rotor from the outboard, side like RB’s center mount design. The the cool air admission is extremely limited. As a result, it this causes the common

understanding to GT-R drivers that OE rotors are very easy to crack. Under such poor operating conditions, RB replacement rotor rings may still hold up, but when under extreme heat, you may still experience other ill effect that can spill over to brake pads and other components -- such as brake fading, pre-mature pad wear, brake juddering, burnt caliper boots/seal, boiling brake fluids, shorten wheel bearing life etc. Check your brake components often to not exceed their limits, and try our center mount design rotors rotors to enable the system to run cooler. Just remember that heat is a brake’s #1 enemy.

RB's two-piece rotors are made to the exact diameter where the pad contacts the rotor to eliminate the rusty rotor lip that forms on the outer edge of the OE rotors.